ENERGY KING 365EK Operations Instructions Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 75
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Rev 03/12/14 ENERGY KING
®
360EK/365EK/480EK Wood/Coal Furnace Owner’s Manual U. S. 11
Installation
Assembling Your ENERGY KING Wood/Coal Furnace
The entire installation should be planned before putting the furnace in place to ensure compliance
with all the requirements outlined in the owner’s manual and any applicable markings on the
appliance.
Your new ENERGY KING Wood/Coal Furnace will have been shipped on a pallet with several
boxed components that will need to be assembled prior to installation. Please see Components for
a list of everything that was shipped along with your ENERGY KING Wood/Coal Furnace.
Once your furnace is placed in your desired location:
1. Remove the protective plastic coating from
the outer cabinet of the Furnace before
assembling.
2. Cast Iron Hearth Plates. Position front and
rear cast iron hearth plates in the burn
chamber. Your primary type of fuel (wood
or coal) will determine how to position the
hearth plates. The words “Wood” and
“Coal” are cast into the end plate on
opposite sides. The purpose of proper
location is to introduce the precise amount
of combustion air into the burn chamber to
promote the most efficient combustion for
either fuel.
a. If you are going to burn wood, position
the hearth plates with the word “Wood”
facing out, not into the burn chamber.
b. If you plan to primarily burn coal, position
the hearth plates with the word “Coal”
facing out.
3. Firebrick. The firebrick in your
ENERGY KING Furnace will have been
installed at the factory; however, they may
have shifted during shipment. If
adjustments are needed, position the
firebrick by standing up on end on the left
and right sides of the burn chamber.
The ENERGY KING 360EK/365EK
Wood/Coal Furnace uses 10 firebricks (5
on each side), while the ENERGY KING
480EK Wood/Coal Furnace uses 12
firebricks (6 on each side).
4. Cast Iron Doors. Mount the fuel loading
door and ash removal door on the front of
the Furnace and secure with the enclosed
door pins.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 74 75

Comments to this Manuals

No comments